The function of the MPPT wind solar street light controller is to reduce light output of the street light when street lighting is turned on.The basic purpose of the MPPT wind solar street light controller is to operate the street lights continuously for a long period of time. When the maximum output of the street light is reached, it should reduce the light output below the maximum output, thereby eliminating the need to adjust the light output level. To achieve optimum dimming at the same level of output as the maximum output of the street light, it is recommended that MPPT wind solar street light controller should be installed close to the street light, and it should be close to the ground with a diameter of more than 20cm, which will ensure a high transmission of wind power.

The purpose of MPPT wind solar street light controller is to provide an electrical connection between a light fixture and a street lamp in a community-type environment, in a low-energy, low-cost environment.MPPT is not intended to replace light sources, as its only performance attribute is the installation technology, which uses the natural solar radiation from the building surface. Its purpose is to reduce the overall electrical load on a lighting fixture by controlling the voltage and current applied to the main (inverting) and secondary (inverting) electrical circuits using an external source of electricity to do the job.The main purpose of MPPT is to provide an independent power source that can be disconnected from the power circuit in an outage; in this particular case, if the street light circuit is removed, MPPT is expected to be activated by the loss of the main circuit.
The MPPT wind solar street light controller is configured to provide a constant 5.0 volt, 2 amp DC. which is supplied in the line connection socket to the battery. the MPPT wind solar street light controller is mounted to the rear with the battery terminal hole, this is so you can install the lamp, it is compatible with all other electrical devices.