language
中国
韩国
韩国
韩国
韩国
韩国
logo

News

Common problems and solutions for hybrid wind solar controller home use

(Summary description)Hybrid wind solar controller home use The overload lamp flickers during load work. It means that the output of the load exceeds 10% of the rated load, and you should check whether the load is overloaded.

Common problems and solutions for hybrid wind solar controller home use

(Summary description)Hybrid wind solar controller home use The overload lamp flickers during load work. It means that the output of the load exceeds 10% of the rated load, and you should check whether the load is overloaded.

Information

1. Hybrid wind solar controller home use The overload lamp flickers during load work. It means that the output of the load exceeds 10% of the rated load, and you should check whether the load is overloaded.

Hybrid wind solar controller home use
2. The hybrid wind solar controller home use suddenly turns off the output during load work, and the overload light is always on. It means that the output of the load exceeds 20% of the rated load or a short circuit occurs, and the load condition should be checked.
3. No charging, no display: Open the upper cover of the hybrid wind solar controller home use and check whether the DC fuse is blown. When a fuse is found, first check whether the positive and negative electrodes of the battery and solar panel are connected incorrectly, and then replace the DC fuse of the same specification after confirming that it is correct.
4. The wind turbine does not turn: when the wind is good, other wind turbines are running normally. When the wind turbine does not turn or the speed is very slow, please observe whether the direction of the tail rudder of the wind turbine is the same as the wind direction, and check Whether the wind-solar hybrid controller shows overvoltage, if the direction is the same and the wind-solar hybrid controller has no overvoltage, try to disconnect the wind-solar hybrid controller from the battery. After the wind-solar hybrid controller stops working, connect the battery again, and the wind turbine still does not rotate. Or the speed is very slow, try to disconnect the wind turbine from the hybrid wind solar controller home use. The wind turbine rotates normally, indicating that the intelligent shutdown system of the hybrid wind solar controller home use is damaged and needs to be replaced.
5. The charging voltage is too high: when the battery voltage is higher than 5% of the upper limit of the charging overvoltage protection voltage, the solar panel or wind turbine still has the charging current measured by the clamp ammeter. This fault may be a charging hybrid wind solar controller The home use is damaged and needs to be replaced.

Keyword:

Scan the QR code to read on your phone

About us   

Projects   

Messages      

Contact us   

Skype: ws.charger
Tel: +
86-755-28227280
Fax: +86-755-28227281
Email:
sales@huaxiaotech.com
Add:Qinghu Industrial Park,Qingxiang Road, 
Longhua District,Shenzhen,518129 CHINA

Copyright © 2015 Shenzhen HUAXIAO Technology Co.,Ltd. 

粤ICP备11104137号