PRODUCTS

Your present location:Home >> Products >> Charge controller >> Wind Solar Street Light Charge Controller with Time and Light Control
  • Name: Wind Solar Street Light Charge Controller with Time and Light Control
  • No.: WSSL

HX-VWG2008 hybrid charge controller is a smart controller controlled by CPU. The controller will adjust the charge current and decide if charge to the battery based on the battery voltage.  Features:
1.Generally keep the battery on full voltage condition.
2.Prevent the battery from overcharge and over discharge
3.Prevent supplying electricity from the battery to solar panels during nights.
4. Reverse polarity protection for battery.
5. Load-off automatically when the battery is over charged.
6. Brake the wind turbines automatically when the wind generator output voltage is too high.
7. The controller will turn into protection state and brake the wind turbine automatically when the current is too large.
8. Manual brake protection for Wind Turbine
9. When load current exceed the controller’s rated current, controller will disconnect load turn into the self-protection state and is automatically.
10. Lightning protection,and can prevent the light interference.
11. Small size(diameter<12cm), Can be installed inside the street light pole.
12. The display with USD connection can be removed easily. It can save power.
13. Backlight display can be seen clear even in darkness.
14. Display is in common use with other HX-VWG series controller
15. The charge controller is always counting the charge or discharge AH of the battery, And the total KWH which is generated by wind turbine and solar panel.
16. When the controller starts up, according to the voltage level of battery (12V/24V). Controller will self-setup the charging-off voltage, the load-off voltage, the load-on voltage, brake current, brake time etc.
17.can setup the charging-off voltage, the load-off voltage, the load-on voltage, brake current, brake time according to their requirement.
18.This controller can be set 5 groups independent switch of the load. Each group can be set by light control or time control or both light and time control.
19.Show current time. It can continue work 3 months even outage
20.It can calculate the local sunrise and sunset time automatically after input the longitude and latitude. The load switch can be set self-adjust based on sunrise and sunset time.
21.The charge-off voltage can’t bigger than the max voltage. In order to protect the voltage from damage.
 

Item Model

HX-VWG2008 WSSL

Rated voltage

 

12V/24V

 

Wind rated power

 

450W

 

PV rated power

 

150W

 

Charge mode

 

constant voltage with current-limiting, PWM

 

Over charge protective voltage

 

14.4V/28.8V(Default, adjust range: 12~15V/24~30V)

 

Over discharge protective voltage 

 

10.5V/21V(Default, adjust range: 10~12.5,20~25.1)

 

Over discharge voltage recovery

 

12.6V/25.2V(Default, adjust range:10.6~14.4,21.1~28.8)

 

Max charge current

 

50A/25A(Default, adjust range: 30~60A/15-30A)

 

Brake time

 

6 Sec(Default, adjust range: 1~60 Sec)

 

Max load current

 

50A/25A

 

No-load loss

 

≤60mA